RIP, EIGRP, OSPF, IS-IS, BGP, MPLS, VTP, STP.
alienkidmj12
New Member
Posts:
33
Joined:
Mon Apr 22, 2013 1:32 pm
Certs:
mcp

help setting up vpn on cisco

Sat Oct 20, 2018 3:52 am

Hi,

Im looking for some assistance with setting up a vpn on my cisco 2851 router.

Cisco 2851 (revision 1.0) with 245760K/16384K bytes of memory.
Processor board ID FCZ104774FT
2 Gigabit Ethernet interfaces
1 Serial(sync/async) interface
1 ATM interface
1 terminal line
2 Virtual Private Network (VPN) Modules
1 802.11 Radio
1 Cellular interface
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
3923640K bytes of ATA CompactFlash (Read/Write)


The VPN service im trying to setup is express vpn,

they have supplied my username, password, shared key,

i believe they use aes as a cipher, and so i have attempted to configure the connection, im a bit lost as to why my crypto are incomplete, and also how i configure my login for username and password. can someone assist,

my config below so far,


crypto isakmp key 12345678 hostname uk-east-london-ubuntu-l2tp.expressprovider.com
crypto isakmp key 12345678 hostname uk-docklands-ubuntu-l2tp.expressprovider.com
crypto isakmp key 12345678 hostname uk1-ubuntu-l2tp.expressprovider.com
!
!
crypto ipsec transform-set expressvpn-berkshire esp-aes esp-md5-hmac
crypto ipsec transform-set expressvpn-eastlondon esp-aes esp-md5-hmac
crypto ipsec transform-set expressvpn-docklands esp-aes esp-md5-hmac
!
crypto map expressvpn-berkshire 10 ipsec-isakmp
! Incomplete
set peer 78.129.189.237
set transform-set expressvpn-berkshire
match address 100
!
crypto map expressvpn-docklands 10 ipsec-isakmp
! Incomplete
set peer 185.217.117.250
set transform-set expressvpn-docklands
match address 100
!
crypto map expressvpn-eastlondon 10 ipsec-isakmp
! Incomplete
set peer 85.203.46.116
set transform-set expressvpn-eastlondon
match address 100

alienkidmj12
New Member
Posts:
33
Joined:
Mon Apr 22, 2013 1:32 pm
Certs:
mcp

Re: help setting up vpn on cisco

Sat Oct 20, 2018 4:15 am

i seem to have solved the Incomplete issue, just added an access list, just need to understand how to authenticate with credentials now.


Return to Cisco Routing and Switching

Who is online

Users browsing this forum: Exabot [Bot] and 113 guests